Perry,
Yes, I remember that switch. I've set it to "Receive" thinking I didn't need it
on "Transmit".
I see from the schematic that this disconnects the coax completely where I have
the signal generator attached. I will definitely check that out when I get to
my workbench
Monday.
Thanks,Lyman KK6LPW
> I am troubleshooting a Ten Tec Omni D that belongs to my boss. I just
> repaired the VFO and that appears to be working OK but the primary problem
> this radio is having is no reception
Near the coax connector is a vertical slide switch that shifts the
receiver'to
a separate antenna jack. slide it up and down a few times to clean the
contacts.
This is not a new situation with that switch. Worth a try....
Perry w8au
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|