I need an A9 board for my 565. The one in mine is messed up. Who ever did the
CAP change did a God Awful job. Traces are pulled from the board, soldering
was awful. I Think I can get this one working (I think this is why the rig cut
off on me Sunday) but I would like a better "looking" board. I also need a
Paragon Display driver board. The one in the Paragon I have is modded to the
point that I can't half figure out what goes where. In this case I might sell
the working (sorta) Paragon for 200.00+ a little for shipping. 727 614 2948
for info or talk about the A9
Sandor Wetsel KG4FETMAKE AMERICA GREAT AGAIN!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|