| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Hercules II PA Bias |
| From: | Gary Hendricks <k4mt1950@charter.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 10 Jun 2019 10:18:19 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I wanted to check to bias on my new Herc II. I have read that you
disconnect the blue wires and place an amp meter and key amp with bias
reading 500 MA per pair.
All of mine read 1.5 A for each pair. I have MRF 458 devices in this amp. Are mine misadjusted or is it 500 ma per device? Thanks Gary K4MT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten Tec trim rings back in stock, Bwana Bob via TenTec |
|---|---|
| Next by Date: | [TenTec] Orion II wantred, wb5xx |
| Previous by Thread: | [TenTec] Ten Tec trim rings back in stock, Peter Bertini |
| Next by Thread: | [TenTec] Orion II wantred, wb5xx |
| Indexes: | [Date] [Thread] [Top] [All Lists] |