| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] PIN diodes |
| From: | Dale Johnson <pastordalej@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 29 Jun 2020 22:24:59 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
What is the right pin diode to replace the ones in my triton 4 IF-AGC board? Diodes 1-3 are the first ones to go out and cause receive sensitivity problems, Right? Thank you, Dale, KB0SYH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Wanted: Corsair II, Malcolm McLeman |
|---|---|
| Next by Date: | Re: [TenTec] Confusion re Omni V 1st IF filters (long and annoying...), Barry Simpson |
| Previous by Thread: | [TenTec] Wanted: Corsair II, Petr Ourednik |
| Indexes: | [Date] [Thread] [Top] [All Lists] |