Good afternoon, Karl:
You may want to try Greenbrook Electronics in North Plainfield, NJ, or Mauser,
or even Amazon...
73,
AA2PM, Paul Mondok
Before printing this document, please think about the environment.
-----Original Message-----
From: TenTec [mailto:tentec-bounces+aa2pm=earthlink.net@contesting.com] On
Behalf Of Karl Heimbach
Sent: Wednesday, December 23, 2020 11:31 AM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] ALC pot for Corsair II
All,
I have a Corsair II that I picked up at a hamfest that needs a bit of TLC.
Somewhere along the line, the ALC pot was cross-threaded when it was installed
in the front panel.
The pot works for about 40% of its rotation, and then shorts. The schematic
indicates that it is a 10K pot. Problem is, that I have not been able to find
a 10K pot with a footprint that will fit.
The original pots are about 50% of the size of commonly found potentiometers
and also have a small diameter shaft.
Does anyone have an idea of where I could find a smaller pot that will fit?
Thank you,
Karl - W5QJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|