Posted by permission of W3EKT.
He doesn't have any support higher than the 35 foot "rocket launcher"
tower. I am posting this as an idea for those without a tall support or
live on a smaller lot. I think it would work with coils in the legs, he
says try bending the legs to fit the space available.
73 Ed
K3IXD
>To: pvrc@qth.net
>Subject: [PVRC] Lazy U for 160.
>X-Mailer: Juno 1.49
>From: "Edward L. Bruns" <edbruns@juno.com>
To: <topband@contesting.com>
>Date: Tue, 09 Mar 1999 01:02:28 EST
>Sender: owner-pvrc@qth.net
>Reply-To: "Edward L. Bruns" <edbruns@juno.com>
>
>For the ARRL SSB contest, I left up the Lazy U I had for 160,
>but removed the end sections of the "other" dipole to use it
>on 75..so no direct comparison this time. But, I can say that
>I worked NP4A, V47KP, VP9ID, and WP2Z on 160 with the
>Lazy U installed with the bottom 5 feet off the ground and the
>top at 35 feet. Barefoot TS-850, hundred watts. I didn't even
>TRY to call any real DX, ie: Europe. And I stayed out of pile ups.
>
>Again, the thing was fed in the center of the vertical 30 foot section,
>no balun, just coax. No attempt was made to pull the coax away at
>a right angle to the wire. The wire was mounted inches from the
>"rocket launcher" used to support the old TA-33 at 35 feet. The tubes
>of the support are 5 inches in diameter, but did not seem to matter.
>No ground radials of any sort, just the #18 wire for the antenna.
>
>The article on this antenna is in the Communications Quarterly, winter
>of 1992 issue, page 81 By Henry Elwell.
>
>Simple, worked. Ed, W3EKT.
>
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|