Sure, Javier. The additional loss form the mismatch between
the 50 ohm output of the matching tranformer at the K9AY loop
and the 75 ohm RG-6 will be inconsequential. You could modify
the matching transformer design so that the output impedance
was a closer match to 75 ohms, but it is probably not worth your
effort.
73 de Mike, W4EF................................
----- Original Message -----
From: "Javier Remoto" <jlopez@plasticosomega.com>
To: <topband@contesting.com>
Sent: Sunday, September 12, 2004 2:04 PM
Subject: Topband: K9AY Loop feeding?
> Hi,
> I will install a K9AY Receiving Loop for the next season, and I would like
to know if may I use RG-6 cable to connect it to my remote antenna switch or
do I need to use RG-8/RG-58?
>
> 73's de Javier
> yv5mbx
> _______________________________________________
> Topband mailing list
> Topband@contesting.com
> http://lists.contesting.com/mailman/listinfo/topband
>
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|