Eric
I'm using metal masts for my 160m Flag here.
The one at the rear is steel, and the one at the front
is aluminum.
Both masts are about 10-15 ft from the vertical wires
of the Flag. Farther is better if you have the space,
but I don't feel that my Flag suffers any that I can
tell.
Good luck and 73
Bob N6WG
-----Original Message-----
From: topband-bounces@contesting.com
[mailto:topband-bounces@contesting.com]On Behalf Of Eric Rosenberg
Sent: Wednesday, June 01, 2005 11:56 AM
To: topband@contesting.com
Subject: Topband: Support for Flags?
I am about to put up a couple of flag antennas in my back yard (one
running 50 degrees, the other at 330 degrees, with a common support for
the back end).
I *thought* I needed to use non-conductive masts (I was planning to use
fiberglass masts (from The Mast Company [www.tmastco.com]) as the
supports, but recently heared that I can use aluminum ones without much
(if any) negative effect. I assume they're lighter and stronger.
The question, aluminum or fiberglass?
Thanks in advance,
Eric W3DQ
Washington, DC
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|