>From Brian K1LI,
>> I read a lot about flags being sensitive to nearby objects...
A minor clarification -- it's not that these antennas are sensitive, but
that they are usually installed at limited-size QTHs and end up close to the
TX antenna.
>> ... and I know how to de-tune those objects, but my question is this: if
>> the object to be detuned is my TX antenna, don't I have to switch the
>> "detuner" in when I'm on RX and switch it back out when I'm on TX?
Yes, the detuning is switched into place during receive, but first check to
see whether the TX antenna actually needs detuning or not. Some dipoles,
inverted-Ls and other wire antennas have been effectively detuned by opening
the T/R relay in the rig or amp. This depends on the antenna impedance,
feedline length, tuner, and anything else in line. It's worth checking
before starting the detuning work.
A shunt-fed tower will almost certainly require detuning. Of course, any
other nearby tower (not fed) with enough height to be an effective
re-radiator at 160M can have a fixed detuning network.
73, Gary
K9AY
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|