Can anyone tell me how to prepare this RG-6 (F-6) for snap-n-seal
connectors? Do I fold the braid back over the jacket? If so, how far?
And is the same true for RG-11 (F-11)?
The temp is going to drop here in two days and I won't be able to do this
after that in time for the Stew Perry. Since the list is in moderated mode,
I'd appreciate a cc to my e-mail address.
There's not time to buy the coax stripper.
Thanks in advance!
73, Mike
www.w0btu.com
On Wed, Dec 19, 2012 at 5:08 PM, Mike Waters <mikewate@gmail.com> wrote:
> I bought some of these from this seller and this eBay listing number, and
> they arrived today. Just thought I'd mention that there are no O-ring seals.
>
> I didn't try them yet; I have to figure out the best way to prepare the
> coax. Any suggestions?
>
> I'm using Commscope flooded quad-shield RG-6 (F-6) with poly foil and
> bonded inner shield.
> Jacket/flooded-braid/foil/braid/bonded-foil/dielectric/CCS.
>
> 73, Mike
> www.w0btu.com
>
> On Fri, Dec 14, 2012 at 5:49 PM, Jim F. <j_fitton@yahoo.com> wrote:
>
>>
>> I bought a new roll of flooded quad shield RG-6 and packages of
>> connectors from 5 sources because they are cheap until I found a package
>> that worked.
>>
>> Here is the one that worked great. Note: this is for Quad Shield and
>> Flooded (with Poly.). If you have Double shield it may not work.
>>
>> Seller: fourpairteledata ( 44493 )
>>
>> 10 Pack Lot - F-Type Compression Connector Male Plug RG6 Quad Shield Coax
>> Cable ( 120796092561 )
>>
>
>
_______________________________________________
Stew Perry Topband Distance Challenge coming on December 29th.
|