Message: 1
Date: Sun, 4 Dec 2016 14:50:55 -0500
From: Larry <pacer99@aol.com>
To: topband@contesting.com
Subject: Topband: coax soldering
Message-ID: <158cb63a7fa-2fd9-563d@webprd-m107.mail.aol.com>
Content-Type: text/plain; charset=utf-8
hi guys,
planning on installing some more beverages. i have a roll of CATV 75 ohm
cable. it is the kind with a double shield. aluminum wrap over tinned copper
shield. there is some kind of sticky on the shield and i dont think that i
can solder efficiently to it.
what is the best way to clean the "sticky" off the shield so that i can
solder to it for PL259's?
thanks,
larry
n7dd
Hi Larry,
I highly recommend you use RG6 F-type compression connectors as opposed to
trying to make a soldered UHF male connection.
Then get F female to UHF male adapters for your radio, or whatever,
connection. Loss is not worth worrying about.
You will save yourself a lot of gnashing of teeth. I learned the hard way
may years ago.
As was mentioned by someone else, the goop is a flooding material to protect
the coax if nicked.
Good luck.
Craig
Craig Clark K1QX
PO Box 209
107 Fitzgerald Rd
Rindge NH 03461
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|