Topband
[Top] [All Lists]

Re: [TowerTalk] What's heating up ?

To: Gary Schafer <garyschafer@largeriver.net>
Subject: Re: [TowerTalk] What's heating up ?
From: Jim Kennedy <kennedyjp@cableone.net>
Date: Mon, 13 Mar 2017 01:01:57 -0400 (EDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Garys suggestion is right on. I assume from the the cap you describe that its a 
doorknob type. If so be sure it is RF rated and not a HV type used in power 
supplies, Total different characteristics. 

Jim
W7ouu

----- Original Message -----
From: "Gary Schafer" <garyschafer@largeriver.net>
To: n2ic@arrl.net, "Topband" <topband@contesting.com>, towertalk@contesting.com
Sent: Monday, March 13, 2017 4:00:42 AM
Subject: Re: [TowerTalk] What's heating up ?

Probably the capacitor. Try 2 or 3 smaller values in parallel to make your
2200pf. Then see if the drift is the same.

Or the coil wire size is too small.

73
Gary  K4FMX

> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
> Steve London
> Sent: Sunday, March 12, 2017 10:42 PM
> To: Topband; towertalk@contesting.com
> Subject: [TowerTalk] What's heating up ?
> 
> I am experimenting with the N4KG reverse feed method for 160 meters on a
> tower with a lot of stuff already on it. I like the possibility that
> elevated radials will be an improvement over my terrible, dry,
> mountaintop ground characteristics.
> 
> As I transmit, the SWR creeps up, pretty significantly. Something is
> clearly getting warm.
> 
> Possibilities:
> 
> - I am matching the 160 feedline with an L-network (series L, shunt C).
> TLW says 7 amps through the capacitor, with 3 watts of dissipation. The
> capacitor measures 2200 pf, the usual transmitting capacitor,
> cylindrical, about 3/4" in diameter.
> 
> - The M2 balun feeding the 40 meter beam on the same tower. I monitored
> the SWR on the 40 meter beam while transmitting on 160. No change in 40
> meter SWR.
> 
> - The M2 balun feeding the KT-36XA on the same tower. I monitored the
> SWR on the KT-36XA while transmitting on 160. No change in KT-36XA meter
> SWR.
> 
> - Gamma match on homebrew 15 meter beam. Gamma match is just a piece of
> RG-8 dielectric/center conductor inside aluminum tubing.
> 
> Suggestions on how to troubleshoot this ? Start by disconnecting the
> feedlines to the baluns ? And once I determine which component is
> heating, what then ?
> 
> 73,
> Steve, N2IC
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>