It sounds like you are effectively reducing the contact area between the
ground rod and the soil. I'm not certain that by leaching salty water
into the surrounding soil you make up for the contact area loss.
Some have tried to get the best of both worlds by using hard drawn
copper pipe as the ground rod. They cross drill holes in the pipe along
its length, pinch the bottom end, drive the pipe into the ground, and
then periodically fill the pipe with either rock salt or Bentonite, so
that they can increase the conductivity of the soil that is in direct
contact with the pipe.
>----------
>From: k4sb@avana.net[SMTP:k4sb@avana.net]
>Sent: Friday, April 18, 1997 7:13 PM
>To: w2up@Op.Net; Dick Flanagan
>Cc: towertalk@contesting.com
>Subject: Re: [TowerTalk] Re: Ground Rods
>
>On the water conductivity issue, I always use a post hole digger to go down
>as
>far as I can before I hit the rock shelf all over this place. But, as a
>standard
>practice, I empty a small bag of rock salt into the hole before filling it
>in.
>
>If I can, ( such as two right next to the house, I leave the hole open or
>fill it
>with leaves, pine straw, ect to the rock level, and periodically, pour
>another
>bag of salt in followed with a a gallon of water.
>
>Don't know if this helps or not.
>
>73, Ed
>-------------------------------------
>Name: Edward W. Sleight
>E-mail: k4sb@avana.net
To: <towertalk@contesting.com>
>Date: 4/18/97
>Time: 4:13:53 PM
>
>This message was sent by Chameleon
>-------------------------------------
>
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|