Towertalk
[Top] [All Lists]

[TowerTalk] Questions->cable cutters

To: <towertalk@contesting.com>
Subject: [TowerTalk] Questions->cable cutters
From: n3hrt@eagle1.eaglenet.com (Martin Gary)
Date: Mon, 15 Sep 1997 12:27:36 -0400
A Dremel tool with a cutting blade works great!
73,
Martin - N3HRT





force12@interserv.com wrote:
> 
> Good morning.
> 
> Steve (K7LXC) commented on cable cutters and parenthetically mentioned "not
> EHS" in regards to what one can cut with them. If you are looking at cable
> cutters, they will often be labeled something like "Not For Steel". This is
> common on the type that can be used in one hand and are intended for cutting
> copper. If you attempt to use these on EHS, even 1/8", you will not be
> successful in cutting, but will be successful in dulling/mashing the blades!
> Your hardware store will like you.
> 
> A cable cutter for EHS is fairly expensive. They have two handles and are
> usually painted red with black blades. They run about $100 (maybe more) for
> something that can cut up to 3/16" EHS. Larger ones cost more, of course.
> 
> Another way to cut EHS is not so sophisticated. One can tape the location to
> be cut with duct tape (or black tape). Then, wearing goggles and gloves, use
> a small disk grinder to cut through the tape and cable. A 4" grinder works
> fine. If you can hold the cable in a vice, or pair of vices, it will be much
> safer.
> 
> There is also a hammer driven cutter, but I haven't seen one for a while.
> 
> In any event, be careful.
> 
> Have a good day and 73,
>                         Tom, N6BT
>                         Force 12 Antennas and Systems
>                         (Home Page   http://www.QTH.com/force12 )
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>