I bought several of the K6NA Aztec RF Baluns for all my beams. They
have performed great on the TH6's and Monos that I have...These things are
GREAT!!....Now the question.
I was going to replace the BN-86's on my TH7 stack, and noticed a
problem. The TH7 has a phasing harness as you know for the 2 driven
elements. The BN86 BOLTS directly to the bottom portion of that harness.
How would I go about installing the K6NA baluns without bolts to the TH7
phasing harness. I really would rather not cut the wires from the balun
to a length of 1 inch and bolt to the phasing line. Maybe this is the only
way....Would I need to readjust the driven elements then?? Rather not do
that also.....
Has this been done by anyone else, or am I looking into this too
closely???
Thanks! Rich N7TR
*******************************************************
Richard Hallman N7TR N7TR@RNODX.ORG
11870 Heartpine St Ex: KI3V, A92FN, HL9RH
Reno NV 89506 (702) 677-1106
********************************************************
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|