Thanks to everyone for the many excellent replies. All were unanimous, and
this message below sums it up. Thank you! My original message:
>> I have 9913
>> going from the shack out to the tower site. I don't want to run the 9913
up
>> a crank up because it's probably too rigid and would be damaged from the
>> lowering/raising motion.
9913 uses a solid center conductor and should not be flexed repeatedly like
up and down on a crankup or on a rotation loop from an antenna to the mast.
It
may eventually crack and break. The new 9913F (flexible) has a stranded
center
conductor and can be flexed to your heart's content.
>>Can I use RG-213 or 8 from the antennas down the
>> tower and connect it to the existing 9913 that goes up to the shack?
I've
>> never mixed coax before, hence my question: Is there a problem with
>velocity
>> factor/or capacitance/or signal loss mixing coax?
For all practical purposes on HF, it doesn't make any difference.Velocity
factor becomes important if you want a specific electrical length of
coax but for general purposes you can ignore the differences. Also
connecting
two pieces of coax with a barrel connector is no big deal either. As long as
you properly weatherproof it, it'll work just fine and the loss on HF is
insignificant.
73, Steve K7LXC
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|