Towertalk
[Top] [All Lists]

[Towertalk] Ball bearings in pulleys

To: <towertalk@contesting.com>
Subject: [Towertalk] Ball bearings in pulleys
From: shr@ricc.net (John Brosnahan)
Date: Wed, 27 Nov 2002 10:26:46 -0600
When I got my first Rohn gin pole the hole in the pulley was SO off-center
that the pulley would wobble and that would get transmitted to the
gin pole itself.  And the whole thing would oscillate back and forth.

So I bored out the aluminum pulley to allow me to press in a bronze
bushing.   You can get various bushings that have been impregnated
with oil and these will ride on the steel shaft (bolt) very smoothly.

Only tricky part is getting the new hole for the bushing in the center
of the pulley.  Easy if you have a lathe like I do--but a bit more tricky
if you don't.  But a 6-pack to your local machinist would probably get
the job done in a couple of minutes.

--John   W0UN


> >  Question:
> >  Is there a ball bearing inside the pulley of the head of these ginpoles
>and
> >  the pulley of Tower Block?
>
>     I don't think any of the above have ballbearings - they're just a pulley
>on a bolt/axle.
>
>Cheers,
>Steve    K7LXC
>TOWER TECH
>_______________________________________________
>AN Wireless Self Supporting Towers at discounted prices,
>See http://www.mscomputer.com
>
>Wireless Weather Stations now $349.95. Call Toll Free,
>888-333-9041 for additional information.
>_______________________________________________
>Towertalk mailing list
>Towertalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk


<Prev in Thread] Current Thread [Next in Thread>