The natural color (white) UHMW will last ~2years in the sun here in the
southeast before the UV breaks it down into a crumbling mess.
Nylatron, on the other hand, is a similar plastic but impregnated with
graphite and an UV blocker, making it an excellent choice for outdoor
bushing applications. It is available from most plastics dealers; use the
yellow pages. That is what I use in the bushings for the SideWinder.
www.idctechnology.com
At 05:42 PM 4/13/2003 -0400, you wrote:
>Hello to all:
>Just a note about these cutting boards. Most restaurants use these and
>have to replace them from time to time for health department reasons. When
>they do, they just toss them. They are usually large sized and thick, with
>some knife wear on both sides...makes no difference for our use, eh?
>
>Just ask the manager of your local hangout to let you know when this is
>about to happen and pickup their rejects for free... Should be enough for
>a lifetime.
>
>Regards,
>Mel Frost
>KD7DCR - Coeur d'Alene, ID
>
>
>
>
>
To: <towertalk@contesting.com>
>Date: Mon, 7 Apr 2003 20:09:14 -0700
>From: "Jim Lux" <jimlux@earthlink.net>
>To: <n8de@thepoint.net>
>Cc: "\(Reflector\) TowerTalk" <towertalk@contesting.com>
>Subject: Re: [TowerTalk] Above the Thrust Bearing
>Message-ID: <002701c2fd7c$3c87cce0$02a8a8c0@office1>
>References: <008b01c2fd5a$06c409b0$1902a8c0@MainDesktop>
> <3E922327.1020306@thepoint.net>
>Content-Type: text/plain;
> charset="iso-8859-1"
>MIME-Version: 1.0
>Content-Transfer-Encoding: 7bit
>Precedence: list
>Message: 10
>
>Don't bother with Teflon... use High density (UHMW) polyethylene cutting
>boards... Less than $10 at your local discount store.. Very good dielectric
>properties, easy to cut (make sure that saw is SHARP), and almost as low a
>friction coefficient as PTFE.
>Unless you were planning to heat your antenna up hot enough where the PE
>starts to flow....?
>
>----- Original Message -----
>From: "Don Havlicek" <n8de@thepoint.net>
>To: "Jerry K3BZ" <k3bz@arrl.net>
>Cc: "(Reflector) TowerTalk" <towertalk@contesting.com>
>Sent: Monday, April 07, 2003 6:17 PM
>Subject: Re: [TowerTalk] Above the Thrust Bearing
>
>
> > Jerry,
> > Get some Teflon sheet and cut a piece to fit. Should last a lifetime.
> > Don
> > N8DE
> >
>_______________________________________________
>
>See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
>Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
>any questions and ask for Sherman, W2FLA.
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
Thanks,
Robin Midgett KB4IDC
VHF+ Glutton
God Bless America, in God we trust.
Southeastern VHF Society 2003 Conference
April 25-26 Huntsville, AL
www.svhfs.org
|