If your cutting clamping slots in the ends of tubing a hacksaw kerf is plenty.
If you want longitudinal slots then a milling bit in a drill press will work
as long as you don't get rambunctious pushing the tubing through.
--
R. Kevin Stover, NØRKX
Systems/Networking
Iowa Quality Beef LLC
3337 L. Ave.
Tama, IA 52339
e-mail:
kstover@iowaqualitybeef.com,
rkstover@mchsi.com
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|