You can indeed do an exothermic weld with flashing. I have never seen a
one-shot to do it however. An exothermic weld using flashing requires a
reusable mold, handles/clamp, and shot charge. The mold I have used is an
erico CRC16002 and a #115 shot charge. Mr. Ron Block did an excellent
grounding presentation at Dayton this year and talked about exothermic
welding copper strap. I enquired later about where to obtain the materials,
his company stocks them! I purchased an entire do it yourself kit from him
which consisted of mold, handles/clamp, igniter, and a quantity of shot
charges. One call resulted in lots of advice and the stuff appearing on my
door step. So my advice is to give Mr. Block a call and avoid the hassle of
finding all the correct pieces. I believe his brother had something to do
with founding PolyPhasor or some such. Mr. Block is a very knowledgeable
resource.
Contact Mr. Ron Block
WR Block & Associates
(800)421-7170
If you use clamps make sure that you remember exactly where you placed them
so you can dig them up and inspect and tighten them at least yearly! What a
pain.....
Paul N. Henning
K9PH
Director of Research and Development
Amtelco
4800 Curtin Drive
McFarland, Wisconsin 53558
www.amtelco.com
paul@amtelco.com
(608)838-4194
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|