Is it just me, or did anyone else get 6 copies of this post?
73, Keith NM5G
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Mark - AA6DX
Sent: Monday, May 09, 2005 12:15 PM
To: Kristinn Andersen; towertalk@contesting.com
Cc: 'Kristinn Andersen'
Subject: Re: [TowerTalk] Making aluminum tubes telescope smoothly,with good
electrical conductivity?
Kristinn ... here is what I would use ... FINGERSTOCK
http://www.surplussales.com/RF/RFFingerstk-1.html
----- Original Message -----
From: "Kristinn Andersen" <tf3kx@simnet.is>
To: <towertalk@contesting.com>
Cc: "'Kristinn Andersen'" <tf3kx@simnet.is>
Sent: Saturday, May 07, 2005 6:37 AM
Subject: [TowerTalk] Making aluminum tubes telescope smoothly,with good
electrical conductivity?
> Hi:
>
>
>
> I am working on an extensible vertical consisting of a 6m/18ft outer
> aluminum tube (40mm/1.5" diameter) and an inner aluminum tube that can
> be extended out of it with a motor mechanism. For certain reasons the
> inner tube has to be substantially slimmer than the outer one,
> probably around 25mm/1" diameter. So, to make a reasonably tight fit
> I will make a narrowing "collar" at the top of the outer tube, where
> the inner one will emerge upwards. Furthermore, at the bottom of the
> inner tube I will fasten a cylinder that almost fills the outer tube,
> providing mechanical stability there. Sort of like a piston inside
> the outer tube. Thus, the mechanical connections or interfaces
> between the outer tube and the inner tube are at the top of the outer
> tube and at the bottom of the inner tube. At these key points I need
> to ensure:
>
>
>
> a) Good electrical contact (so that antenna currents can continue
> from
> the outer tube to the extended inner tube;
>
> b) Minimal mechanical friction as the inner tube is pushed up and
> retracted back down.
>
>
>
> Are there any suggestions on this? What metal should I use that
> slides with low friction against the aluminum tube wall, does not
> corrode at the contact and provides good conductivity?
>
>
>
> 73 - Kris, TF3KX (http://www.simnet.is/net/tf3kx)
>
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers",
> "Wireless Weather Stations", and lot's more. Call Toll Free,
> 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|