Re: [TowerTalk] Pinning a high carbon steel mast

[Hector Garcia XE2K <j_hector_garcia@sbcglobal.net>]

Terry:

i will try to find a Magnetic drill press, i use it in
several works  where thick steel  need to be drilled .

i think some models can fit at the tower(45 -55 )
check your equipment rental company
the one i use is from Milwaukee Brand, but there are
De Walt and others  

Hector XE2K

--- Terry Gerdes <terry@ab5k.net> wrote:

> All,
>  
> I need to pin one of the Texas Towers high carbon
> steel masts in the air.   I have pined several steel
> masts but all on the ground with a drill press.  Any
> advise?  
> 
> Thanks,
> 
> Terry - AB5K
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
>
http://lists.contesting.com/mailman/listinfo/towertalk
> 


Hector Garcia XE2K / XF1K
Mexicali B.C  DM22fp

http://www.dxxe.org
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk