Also just for informational purposes.....keep in mind that the type of
rivets used by FORCE 12 for their antennas is not a common rivet. They sell
them if you need replacements but they are not so common that you can walk
into a Home Depot and buy them. -Mike
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Roger (K8RI)
Sent: Sunday, April 22, 2007 12:05 AM
To: Scott Millick; towertalk@contesting.com
Subject: Re: [TowerTalk] pop riveters
Don't forget to make sure the pop rivett shaknks and gun fit each other.
OTOH a good mechanical gun should make the standard Aluminum and Stainless
Steel rivetts almost effortless.
Roger (K8RI)
> Does anyone know where to get a air powered pop riveter as looked at
> Lowes and there was none there I have a couple of Force 12 to put
> up and the hand gets real sore after a while as I have a problem with a
> tendon
>
> Scotty K9SM
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|