Will a Yeasu 2800DXA fit? My tower is on order. Same #6 top section on a
LM-354HD SP. I was going to order the rotator soon. This got me worrying if
the Yeasu will fit.
John
Wa5zup
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of KJ6Y@aol.com
Sent: Sunday, August 05, 2007 9:58 AM
To: rustyhill@earthlink.net; towertalk@contesting.com
Subject: Re: [TowerTalk] Tailtwister 2, Tashjian tower
Rusty,
You can use the T2X in the LM-470, if that is the model you have. You'll
need to use spacers to raise the plate up about 1 1/2" inches, to allow the
rotor to clear the cross braces. Karl Tashjian can supply them or you can
make
your own out of a piece of angle iron. The tower will telescope all the way
down with the rotor install.
If you need I can supply you a picture of the plate with the spacers.
Skip, KJ6Y
_Communications Service Co_ (http://members.aol.com/kj6y/skip.html)
818-887-3569
************************************** Get a sneak peek of the all-new AOL
at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|