Does anyone on the list have experience installing an Alpha-Spid rotator in
a US Tower TX455?
I can manage to get the rotator inside the upper section but it seems that
the stand-pipe the rotor mounts to needs to be raised about 2 inches off the
rotor shelf so the rotator motor assembly can clear the side braces. Anyone
ever try this combination of tower/rotator? If so, what was your solution?
I'm thinking about trying to locate some of that white cutting board
material (UHMW Polyethylene??) to use for a thick shim.
Thoughts or experience with above is welcome.
Thanks,
Brad - N8SNM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|