We had a KT34XA stacked below the older version of the Cushcraft and didn't
have problems with interaction at 6D2X. They were about 12 feet apart. When
I put up my tower I put the newer version of the 40 - 12' feet above my
Force 12 C3E antenna and had lots of problems with interaction. I ended up
turning the tribander 90 degrees from the XM-240 and it was fine. I think
the "ungrounding" of the driven element on the newer version of the 40 may
be the culprit but I have no evidence to back it up.
Bill, W5VX
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Andre Van Wyk
Sent: Saturday, January 05, 2008 10:13 PM
To: Tony Brock-Fisher; towertalk@contesting.com
Subject: Re: [TowerTalk] XM-240 and KT-36XA Interaction
I had a KT34XA and a 40M2 on the same tower. The 40M2 was on the top.
I had serious interaction, and the SWR on the 40m beam went crazy...
I then mounted the 40m beam 90 deg to the KT34XA and this fixed the problem.
Only issue was keeping sanity with rembering which beam pointed where.....
73
KR5DX
----- Original Message -----
From: "Tony Brock-Fisher" <barockteer@aol.com>
To: <towertalk@contesting.com>
Sent: Saturday, January 05, 2008 8:31 PM
Subject: Re: [TowerTalk] XM-240 and KT-36XA Interaction
> I have a KT-36XA 9 feet above a 40-2CD. I have noticed a serious
interaction between the two - specifically, the SWR on 40 goes above 3:1
when the XA boom is parallel to the elements of the 40 - i.e. the booms are
90 degrees to each other. I have not noticed any problems on 10-20 on the
XA. I used to have the same setup with the KT-34XA and don't recall having
the problem, so I suspect it is caused by the fact that on the '36, the
parasitic elements are grounded to the boom by metal boom-element clamps,
and this makes the boom resonant on 40. In my setup, the XA is on top, and
the 40 is on a swinging-gate mount, so they are independantly rotatable. If
I really need to, I can rotate the XA to fix the problem - but this would
not be a good solution for multi-op. I think if you mount them on the same
mast, with the booms parallel, there should not be a problem. Anybody have
a ferrite bead choke with an ID of 3 inches?
>
> -Tony, K1KP
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|