Hello Towertalkers
My plan is to construct a 160m vertical using 4 inch irrigation
tubing 90 ft tall, with 4 top loading wires spaced 90 degree and
sloping down at 45 degrees . My target freq is 1.830 but would like
to make the top-loading a bit short so that the antenna was resonant
about 2 MHz. Then put a small (a few uH) loading coil at the base to
bring the antenna to resonance at the desired frequency. I am
placing the antenna 300ft away from any other structure , hoping for
no interaction . I'll start with 32 ground radials and add more
later, not sure on the length ? 90ft or 130ft ?
two questions
how long will the top-loading wires be for resonant at about 2 MHz
using # 14 copper insulated wire?
how long should I make the ground radials ?
Thanks Ed N5DG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|