Towertalk
[Top] [All Lists]

Re: [TowerTalk] Lighting protection for roof mounted tower

To: Ray <rayn6vr@cableone.net>
Subject: Re: [TowerTalk] Lighting protection for roof mounted tower
From: k9mi@comcast.net
Date: Thu, 13 May 2010 13:37:59 +0000 (UTC)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

Ray, I think I would take the long way around. I imagine you will be using good 
feedline and won't notice enough loss difference in the feedline to notice it. 
Just my opinion. 



73 - Mike K9MI 




----- Original Message ----- 
From: "Ray" <rayn6vr@cableone.net> 
To: towertalk@contesting.com, towertalk-request@contesting.com 
Sent: Thursday, May 13, 2010 12:36:10 AM GMT -05:00 US/Canada Eastern 
Subject: [TowerTalk] Lighting protection for roof mounted tower 

I have an 8 ft roof tower that I am debating where and how to install. My 
concern is lighting protection and the way I would like to run the coax. 
This roof tower will hold a 3 el 6m yagi, small yagis for 2m and 440mhz, and 
a 2m vertical on top. My radio room in almost in the center of the house. 
The run for all my HF coax and cables from the station to the Single Point 
Ground is about 30 ft long running under the raised floor. We do get late 
summer monsoon rains and lightning. 
  
First option: mount the roof tower above my shack. I would run the coax 
cables and #4 grounding wire straight down, through the roof and attic and 
into a living room divider wall with a 90 degree sweep to my shack. The coax 
run would be about 30 ft. There are #4 ground wires both in the attic and 
raised floor that I could connect the roof tower ground wire to. 
  
Second option: mount the roof tower at about the same place and run the coax 
to the edge of the roof, down to ground level, then into my SPG. The total 
RG8 coax run for each antenna and ground wire would be about 85 ft. This 
length of coax can start to lead to losses on the VHF frequencies. 
  
My concern is about running the roof tower cables thru the house thereby 
creating a possible lightning path into the house vs. making the longer 
cable runs to the SPG. I do have two 70 ft HF towers nearby with quite an 
extensive ground system on each. All ground rods (about 50) are 
interconnected with #4 wire to each tower, the SPG and the house mains 
input. The roof tower would be somewhat dwarfed by the two HF towers, but 
when lighting strikes, we all know that it will go anywhere and everywhere. 
  
What are the thoughts, comments and opinions about bringing my 6m and VHF 
cables through the house? I would sure like the shorter coax runs, but 
safety is my concern. 
  
Tnx, 
  
Ray, 
N6VR 
  
Chino Valley, AZ 
_______________________________________________ 



_______________________________________________ 
TowerTalk mailing list 
TowerTalk@contesting.com 
http://lists.contesting.com/mailman/listinfo/towertalk 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>