----- Original Message -----
From: "Bill Aycock" <billaycock@centurytel.net>
To: "Kathy Bookmiller" <wb2aio@yahoo.com>
Sent: Monday, May 17, 2010 9:17 PM
Subject: Re: [TowerTalk] thrust bearing lubrication
> That Allen Head screw is there to put the balls in the bearing, and to
> take them out to disassemble it. The information I got was to NOT lube it,
> supposedly because the grease collects dust and dirt.
> No matter what you do, it is not a good bearing. Hard steel balls in an
> Aluminum race is asking for trouble. That rumbling sound is the balls
> bouncing in and out of pits in the race.
> Actually,I still use the old one I got in a package deal; I took the balls
> out, and use the remains as a centering device, and to hold the mast when
> maintenance needs it.
> Good Luck-- Bill--W4BSG
>
> ----- Original Message -----
> From: "Kathy Bookmiller" <wb2aio@yahoo.com>
> To: <towertalk@contesting.com>
> Sent: Monday, May 17, 2010 7:47 PM
> Subject: [TowerTalk] thrust bearing lubrication
>
>
>> Hi TTers,
>> I got that Rohn 45 tilt-over down and home last week. In remarkably good
>> condition. Only thing I wondering about is the TB3 thrust bearing and how
>> to lubricate it. It turns freely but has a notable rumbling sound and
>> feel to it. I notice at the bottom of the inside shaft area where to mast
>> passes through, is a recessed Allan head fitting/plug. Would this be the
>> place to remove and squirt in some white grease? And then replace the
>> plug?
>> Thanks for your guidance,
>> Kathy
>>
>>
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|