Towertalk
[Top] [All Lists]

Re: [TowerTalk] TL-922 grid chokes

To: towertalk@contesting.com
Subject: Re: [TowerTalk] TL-922 grid chokes
From: Todd Coulter <coulter@bellsouth.net>
Date: Thu, 5 Aug 2010 07:59:42 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
There is lots of good information on this site. Take a look.
 
http://www.somis.org/
 
 
                      73's
                     Todd
                    N4JRZ

--- On Thu, 8/5/10, Jim Thomson <jim.thom@telus.net> wrote:


From: Jim Thomson <jim.thom@telus.net>
Subject: [TowerTalk] TL-922 grid chokes
To: towertalk@contesting.com
Date: Thursday, August 5, 2010, 10:45 AM


Date: Wed, 4 Aug 2010 10:34:40 -0500
From: rcm@mail.icnet.net (Randall Mullinax)
Subject: [Amps] TL-922 grid chokes

The grid chokes in my TL-922 were replaced with 10 ohm resistors 
by the previous owner.  The amp works fine except on 10 M where the 
resistors go up in smoke within a few seconds.

This bring up several questions.

1. Is the amplifier oscillating on 10 M?

2. Should I replace the resistors with the factory 470 uH chokes 
or directly ground the grids?

3. Where can I get replacement grid chokes?

4. I?ve read about adding/increasing negative feedback.  Does anyone 
have suggestions?

Thanks for any and all comments.

Randy
AD5RM

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>