Towertalk
[Top] [All Lists]

Re: [TowerTalk] soldering radials (or any outdoor connection)

To: David Gilbert <[email protected]>, [email protected]
Subject: Re: [TowerTalk] soldering radials (or any outdoor connection)
From: Bill Aycock <[email protected]>
Reply-to: [email protected]
Date: Thu, 24 Mar 2011 12:21:33 -0500
List-post: <[email protected]">mailto:[email protected]>
David--
Your last sentence here is true, but has nothing to do with degradation 
of wire joints. Lead is forbidden in water pipes because it tends to 
leach into the water, and is a poison. Lead particularly causes brain 
damage in developing children. That's why lead is also forbidden in paint.
The response of lead solder is a wide-range variable, and is affected by 
soil and air conditions, so there will be wide differences in experience 
on its durability.
Bill--W4BSG

On 3/24/2011 11:34 AM, David Gilbert wrote:
> Moisture is a big issue for standard lead-tin solder and over time it
> can degrade a typical solder joint to the point of failure, although I'm
> sure it also depends upon other chemical influences.  Whether that would
> happen in any of our remaining lifetimes is a point of conjecture.
> There is a reason, however, that lead-tin solder does not meet code for
> soldering copper water plumbing.
>
> Dave   AB7E
>
>
>
> On 3/24/2011 6:02 AM, David Jordan wrote:
>> Hmmmm,
>>
>> I've had some wire antennas up in the air for over 20 yrs.  Used rosin-core
>> solder.  Surface looks weathered but below the surface the solder is stable,
>> connection good.  Location is high acid, salt, blown sand/dust, relatively
>> high pollution.  YMMV
>>
>> I use silver solder on pressurized copper tubing HVAC connections but don't
>> waste it on antennas and the melt temperature is higher risking compromise
>> of the small wires.  Never saw the need to use silver solder for antennas so
>> I guess preferred is in the eye of the beholder, as in hold still so I can
>> get a good solder joint!
>>
>> 73,
>> Dave
>> Wa3gin
>>
>> -----Original Message-----
>> From: [email protected]
>> [mailto:[email protected]] On Behalf Of don daso
>> Sent: Wednesday, March 23, 2011 12:39 PM
>> To: [email protected]
>> Subject: [TowerTalk] soldering radials (or any outdoor connection)
>>
>> The preferred method is to use Silver Solder.
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> [email protected]
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>