This works.
http://www.eham.net/articles/23198
I soldered male adapters onto my pipe, and used a hose bib adapter.
73!
-Adam
On 5/25/2011 8:28 AM, Dan Bookwalter wrote:
> Ok , I have most of my ground system planned out , my plan is to use copper
> pipe
> (type "L") and silver solder flashing to them from the tower etc... my issue
> is
> how in the world do you guys drive copper pipe into the ground , I have
> access
> to a 1/2" hammer drill , but , the pipe is too large for that , I am going to
> check into a ground rod bit for it , but , I am still not so sure if that
> will
> work.
>
> Suggestions ??
>
> Dan N8DCJ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|