I bought a used 1000DXA and I had the IDIOM PRESS rotorcard for my 800SDX
refurbished for the 1000DXA (800 won't work in the 1000DXA) but when I got
it back from IDIOM PRESS the rotor card would not calibrate with the
1000DXA. When adjusting the OUT VOL ADJ on the rotor for calibration as per
the calibration procedure there was no change. There is no change in voltage
on pin 4 of the DIN connector which is used for the signaling. Has anyone
had this problem and know which part of the circuit is bad. After contacting
Rob he thought it might be an issue with the card but he has received it and
it tested fine with him, I'm waiting for it to get back to me now and move
to the next step, don't know what that is yet but I'm ready to go there!!
73
John
KO4XJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|