Greetings:
I note the comment about CadWelding to a tower
leg. I have seen posts here (where else?) on how
to do it and then, just "don't do it".
The installer I am using wants to exothermically
attach my #2 copper to the legs of an AN-HD60
tower, whose legs are definitely not thin.
This was in response to my failed attempts to locate
any "stainless shims" for clamping the #2 to the
legs.
Comments, please.
Warren; W7WY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|