Towertalk
[Top] [All Lists]

Re: [TowerTalk] Recabling info needed for US Tower HDX-589

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Recabling info needed for US Tower HDX-589
From: W8AEF <w8aef@q.com>
Reply-to: w8aef@q.com
Date: Tue, 22 May 2012 13:36:16 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I had a similar experience when the drive chain broke on a friends 
HDX-589.  Incredibly poor design to put the weakest link (the chain) in 
the drive line after the worm drive.

It really makes me appreciate my LM-470 that has a belt drive from the 
motor to a worm gear and the output of the worm gear is welded to the 
cable drum.  If the belt should break nothing will happen.

de Paul, W8AEF

ZF2JI/ZF2TA 8Q7AA FO8DX/FO0PLA XZ0A VU7RG/VU3PYM TX5A A52PP


On 5/22/2012 1:04 PM, Bill Erickson wrote:
> I have had the misfortune of a cable breaking on my US Tower HDX-589. The
> fall from 89 feet to 23 feet didn't hurt it, but the stop at the bottom was
> a killer! I am in the process of fabricating 5 new pulley brackets and
> replacing some of the 2 inch by 1 inch "U" channels that were bent or whose
> welds to the upright tubes were broken.  No problem there. I have been
> unable to get any help whatsoever from US Tower. My cables were damaged in
> the fall/stop so I do not want to trust measurements on them to have new
> cables made. Does any one have the dimensions of the various cables, and a
> cable routing diagram for this tower? Any help would be greatly
> appreciated. I have already missed 2 "Must Have" DxPeditions. Thanks and
> 73,   Bill    N6MXU
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>