Why not measure the diameter and length of the winch drum and then look for
an equivalent? Companies like West Marine have boat and trailer winches. I
use one to raise and lower my vertical. One important consideration is how
much load the winch can handle. It is one thing to raise a telescoping tower
straight up and down and it is another thing to raise a full size tower that
is a tilt over arrangement. The latter requires a load rating that exceeds
the moment of force of the tower at the lifting point.
Best Regards
Dan Schaaf
K3ZXL www.k3zxl.com
60 Meters www.60metersonline.net
----- Original Message -----
From: "K8RI" <K8RI-on-TowerTalk@tm.net>
To: <towertalk@contesting.com>
Sent: Friday, June 08, 2012 3:14 PM
Subject: Re: [TowerTalk] Winch
> On 6/7/2012 3:42 PM, Duane Heise - AA6EE wrote:
>> Steve:
>>
>> I had emailed Janet at HRO & she suggested that you might be able
>> to
>> help. I have a TriEx H-471 four-section 71' tower/ The winch is rusty
>> (see
>> attached pix)
>
> Hate to tell you this but, most groups, this one included, do not post
> attachments. You'll either need to put them up on the Internet and link
> to them or e-mail them to those who can help.
>
> 73
>
> Roger (K8RI)
>
>> & needs to be replaced. However, I can't find out how much
>> cable capacity the old winch has. The winch cable is 3/16".
>>
>> I could get a similar winch at Grainger's but the 3/16" cable
>> capacity is
>> only about 70'. That may not be enough. Any idea?
>>
>> 73, Duane, AA6EE
>>
>>
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|