Heat slightly with a heat gun (or blow dryer) until it's pliable but not
liquid and just "glob" it on there. Do it twice to be sure you have a
good seal. More is not always better, much like solder. For applying to
wire (like guy wire), get it just as pliable and run the block down the
wire. Easiest to work in sections.
Do it when you're sure it's dry. You don't want the wax trapping
moisture against the metal.
Good luck,
Mike N1TA
-------- Original Message --------
Subject: [TowerTalk] Beeswax application
From: "John Holmes" <w9ily@arrl.net>
Date: Mon, June 11, 2012 7:23 pm
To: <TowerTalk@contesting.com>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|