| To: | <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Vertical Radials |
| From: | "James Setzler" <jms_k1sd@verizon.net> |
| Date: | Tue, 25 Jun 2013 09:24:47 -0400 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I'm going to be phasing a pair of verticals (HF2V) on a small lot.
Should each vertical's set of radials be isolated from each other or would
it be OK to allow them to overlap. Or, would it even be more advantageous
to connect both sets of radials together electrically/physically?
73 James K1SD
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TowerTalk] UST bolt Torque question, Jim Thomson |
|---|---|
| Next by Date: | Re: [TowerTalk] Vertical Radials, David Robbins |
| Previous by Thread: | [TowerTalk] UST bolt Torque question, Jim Thomson |
| Next by Thread: | Re: [TowerTalk] Vertical Radials, David Cole |
| Indexes: | [Date] [Thread] [Top] [All Lists] |