Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotator Help

To: n0tt1@juno.com
Subject: Re: [TowerTalk] Rotator Help
From: Richard Zalewski <dick.w7zr@gmail.com>
Date: Tue, 15 Oct 2013 16:51:43 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks for all of the tips.  Will give it a go.  I think the manufacturer
of these rotators was Lance Industries in Sylmar, CA.  They are out of biz.


On Tue, Oct 15, 2013 at 4:39 PM, <n0tt1@juno.com> wrote:

> Richard,
>
> Just a guess on my part, but the case is probably
> held together by some "tabs" and "hooks"  (for lack
> of their proper names).  See if it is by pushing in
> along the seams.  If not then.....
>
> Is the plastic case a "hard" plastic?  Too
> hard to bend by pushing in at a seam?
> If it is, then the case might be glued together.  In that
> situation, I would use a thin, sharp utility knife, penetrate
> one of the seams, then nudge the knife along the seam with a
> small hammer...much better control that way...less chance
> of injury to yourself.  That, and a lot of patience, should
> open the case if there's no other way to get it done.
>
> Have you tried to find the manufacturer?  Maybe they
> would tell you how to get in it after you made it clear
> that you are an "electronics professional", yada-yada,
> and KNOW how to work on it safely.  :D)
>
> Hope that helps!
>
> 73,
> Charlie, N0TT
>
> On Tue, 15 Oct 2013 12:09:09 -0700 Richard Zalewski <dick.w7zr@gmail.com>
> writes:
> > I have a brand new old stock Colormaster LC100B rotator.  This would
> > also
> > be the same as the Radio Shack 15-1225 and probably several other
> > brand
> > names.  I need to get into the controller without using a 2lb
> > sledge.
> >  There is only one visable screw under the unit and that does
> > nothing.
> >  There are no screws under the rubber feet (usual hiding place).
> > Internet
> > searches turns up nothing for me.  Anyone help on this?
> >
> > --
> > Tnx es 73
> > Richard W7ZR
> > www.w7zr.com
> >
> > *Be joyful in hope, patient in affliction, faithful in prayer*
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



-- 
Tnx es 73
Richard W7ZR
www.w7zr.com

*Be joyful in hope, patient in affliction, faithful in prayer*
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>