+1.
WD40, elbow grease and scotch brite work wonders.
Chris
KF7P
On Feb 22, 2014, at 12:47 , Ralph Bellas wrote:
Doug, I use WD40 and a green scouring pad. I wear gloves for this job because
your hands will get stained. It seems to work as well as fine steel wool.
Invariably I got a sliver of steel wool in my hands. In 40 years I always got
used antennas and refurbished them. If a plated U bolt was rusted I found a
galvanized one and replaced always what nuts and bolts I could with stainless
steel & anti-seize.RalphK9ZO
> Date: Sat, 22 Feb 2014 09:46:36 -0800
> From: dougwe2@gmail.com
> To: towertalk@contesting.com
> Subject: [TowerTalk] Penetrox cleaning
>
> I recently became the owner of a used KT34M2 that had been up for several
> years. Is it advisable to completely disassemble and clean off all the
> Penetrox before putting it back on the tower?
>
> What's the best method for removing that gunk?
>
> Thanks!
>
> Doug
> K7IP
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|