I have a m2 2800 on my 70' Rohn 45, with a 20 foot molly mast. It has a 2
ele 40 on top of the mast and a TH7 at the top of the tower.
It's never missed a lick.
I use #16 for the motor and cat 3 phone line for the reed switch. I'll be
switching to the packaged (2ea #12 or 14 and one shielded pair for the reed
switch) rotor cable this summer.
73
Jim W7RY
-----Original Message-----
From: Joe Barnes
Sent: Monday, April 28, 2014 6:16 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Rotors
I am hopefully about to change out rotors on 2 of the towers here. Does
anyone have input or experience with the M2 2800 rotor or the Pro sistel
PT61D antenna positioners? Right now I am using a Yaesu G1000DXA which
really isn’t cutting it and an Alpha Spid which is better but still not
quite enough. On one tower I will be turning a long boom 6 meter 8 element
beam along with 2 16 element long boom beams. The other tower has a Telrex 6
element 20 meter monoband beam on a 46 foot boom and a Hygain 5 element 15
meter beam the 155ba I forget the boom length. I have 2 thrust bearings on
each tower so vertical load isn’t a problem. Thank you for your help.
N4JBK
---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|