the g-2700 and g-2800 rotors have an extra feature the g-800 doesn't. and
while they use the same plugs and CAN power each other, the g-800 and g-1000
series do not have the 'near the stop slowdown' feature. that feature uses the
6th wire that is not connection on the g-800 and g-1000 rotors.
Nov 2, 2015 12:35:50 PM, k0dan@comcast.net wrote:
YAESU G-800SDX ROTATOR CONTROLLER
This is the rotor control box for the Yaesu SDX series rotators. It is
compatible with the G-800, G-1000, and G-2800 rotors, and also compatible
with the "DXA" series of rotors if you change the connectors or build a
"pigtail" to match the connectors. The wire pinouts on rotator and control
box are identical, so the devices are virtually interchangeable.
I purchased this unit as a spare controller, it was serviced by Yaesu
(California), and has sat on the shelf as an unused spare. I just tested it,
and it works fine, all controls (speed, presets, right/left, meter, and
panel light) all work as-new. Cosmetically, the unit is as-new, photos
available on request.
Item is sold as-is, no returns, but guaranteed not D.O.A. $200.00 + $15.80
USPS Flat Rate Box.
Thanks and 73,
Dan
K0DAN
k0dan@arrl.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|