With MIG and TIG, or Plasma torch I don't get near to that current.
With mine it just says to keep clear of the cables. I'll have to look
up which one it is.
They are so much easier, I haven't used a stick, or buzz box in many years
Thanks,
Roger (K8RI)
On 2/25/2016 Thursday 2:40 PM, Patrick Greenlee wrote:
Roger, you should run the welding leads twisted together to form a
twisted pair as much as possible. Bring the leads to the weld site
from in front of you not past you to the site. Clamp the ground clamp
as close as possible to the weld site. Don't put your body any closer
to the weld site than absolutely necessary. Don't exceed about 160 amps.
The above is from the Medtronic folks who made my ICD. I'm exploring
the possibility of a mu metal shield, mu metal as made into fine
strands and woven into flexible cloth to be worn beneath my welding
leathers.
I have to avoid magnetic fields near my ICD as it has a switch inside
that is magnetically operated so a tech can "flip" the switch with a
small hand held magnet. Speaker magnets in a cell phone are one no no
along with refrigerator door magnets etc.
Patrick NJ5G
On 2/25/2016 12:45 PM, Roger (K8RI) on TT wrote:
It all depends. I have a defib with a pacemaker back-up. The only
restriction was no cell phones in my shirt pocket.
I can arc weld and run the legal limit on any band.
It's been so long that I've forgotten who made it and I don't know
where my wife stashed the papers.
Most, but not all, of these devices are pretty much RFI proof. I
researched the web and found the best claimed RFI proof by I believe
it was the Cleveland center (Institute - Clinic). At any rate that
was what they use here and max power on HF plus several hundred watts
on 50, 144, and 50W on 440 (Legal limit in this part of Michigan)
have never bothered it.
They gave me a tutorial on welding which basically said, do not run
the cables in front of my chest, but run them up each side.
The programming is done via 900 MHz digital I do have a monitor at
home that does a diagnostic twice a year and would call home were
there an event.
I had a stroke, then 3 years later a heart attack and in 3 more
another stroke before "they" discovered the problem was my heart
(A-fib) after prolonged elevated heart rate.
All came with no advanced warning. So no more climbing, or flying
airplanes. Had any of them happened while flying or climbing, I
would have been SOL.
73 es good luck.
Roger (K8RI)
On 2/25/2016 Thursday 12:01 PM, Kathy Bookmiller via TowerTalk wrote:
Sorry about this but it may affect many of us eventually.
Yesterday I went for a stress test and got some bad results. I have
a left bundle block and they want to me to have a pacemaker
implanted ASAP.
Obviously this is distressful as I've been in excellent health for
my 68 years and now this:(
One of my first thoughts was are pacemakers prone to RFI? I asked
the surgeon about this and he said he'd never heard of this before
in his practice.
I'm wondering if any of the readers here have had any experience
with pacemakers/RFI issues? I know over the years I've seen
references to it in an offhand way but didn't pay much attention as
it didn't apply to myself at the time.
My beam is only 20-25' directly above me, as can be seen on my qrz
page.
Any thoughts/experiences?
Kathy W2NK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|