Greg,
I have always strived to insert the mast in the fist/2nd section of tower (
INSIDE ) then raise the mast through the bearing with the gin pole. you
talked about CRAIN If you have the Jib Height over center a dual choker and
dropping it down is a doable option. you'll need to reach the choke lines or
drop it to a lower height and then tighten the dual thrust bearings to secure
it in temporary place till you install the antenna .
my .02
wane W3EA
________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of Greg Best via
TowerTalk <towertalk@contesting.com>
Sent: Wednesday, November 8, 2017 9:10 PM
To: towertalk@contesting.com
Subject: [TowerTalk] GETTING A LARGE MAST INSERTED INTO TOWER HAVING 2 EXISTING
THRUST BEARINGS THAT WON'T COME OUT
I have a large diameter mast going into my SSV tower that has dual thrust
bearings in it and I need some good ideas on how to actually insert the mast
because it is heavy, awkward, and not much clearance between the mast OD and
the thrust bearings’ ID. The mast is 23 ft long, of which 15 ft will stick out
the top of the tower. The mast is 3.5 “ OD with 0.25” wall and it weighs almost
200 pounds. So it is not just something a couple of guys can pick up and shove
through the first thrust bearing. The thrust bearings are about 6 feet apart.
I think the difficult thing is to line it up and get it started the first few
inches. The thrust bearings are 5” or so long. Any suggestions?
I would like to put it in the tower section while the section is on the ground
since it will likely be easier to control versus putting it in via crane after
tower is already stood up (and also less subject to wind.)
Greg, N9GB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|