I have 2 partially nested 4 squares and also a 2el array, all in a patch of
uneven woods roughly 65' x 135'
2el 160m runs along West side of the rectangle.
The 80m array is roughly in the center of the rectangle
The 40m array is on the far NW corner of the 80m array, with the NW 40m
element just barely outside the NW element of the 80m array.
I have taken dB measurements with my antenna analyzer as the 'transmitter'
and my rig as the RX and things
appear quite normal.
At most (and it's hard to quantify as there is external clutter in the NW
direction on my property) there
is a slight aberration in the NW direction on 80m.
Mike VE9AA...wire 4 squares, hung in trees, 2 raised radial per element. I
posted my readings on this very reflector a year or so ago with all the
readings etc.
Good luck !
"Build it and they will call" (K1ZM quote)
Kris
Sent: Friday, April 20, 2018 19:24
To: towertalk@contesting.com
Subject: [TowerTalk] Nested 4-Squares
Is nesting 4-Square arrays a good idea? By that I mean, for instance, an 80m
4-square inside a 160m 4-square. I was about to model this but it occurs to
me that someone has probably already done this exercise.
Good idea or bad idea?
Kris N5KM
_______________________________________________
Mike, Coreen & Corey
Keswick Ridge, NB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|