On my old Ham IV, I used the usual spade connectors and sealed them with
Liquid Tape. I had considered using a water-proof 8-pin trailer
connector, but I was pressed for time.
Bill W6RGS
On 8/11/2018 9:31 PM, Bob K6UJ wrote:
I am replacing the old rotator cable going to a T2X on my tower. Can you recommend
a better solution for connecting the wires to the rotor other than the stock solution ?
I see the newer T2X's have an inline plug but heard that it isn't very reliable.
thanks,BobK6UJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|