Towertalk
[Top] [All Lists]

[TowerTalk] Tower Grounding and Lightning Protection

To: "'Mickey Baker'" <fishflorida@gmail.com>
Subject: [TowerTalk] Tower Grounding and Lightning Protection
From: "Jim" <jimw7ry@gmail.com>
Date: Sun, 7 Oct 2018 22:45:48 -0500
List-post: <mailto:towertalk@contesting.com>
BTW, a polyphaser (or any coaxial lightning prevention device) is not designed 
to mounted outside on one of those clamps that clamp to the top of a ground 
rod. They are not weatherproof.

 

In the commercial world, the polyphaser is just inside of the building.

 

 

73

Jim W7RY

 

 

From: Mickey Baker [mailto:fishflorida@gmail.com] 
Sent: Sunday, October 7, 2018 10:14 PM
To: jimw7ry@gmail.com
Subject: Re: [TowerTalk] Grounding wire choices

 

I have one, about 3 years old, strap from the grounding system into my SPG on 
the entry wall. Not buried, used the Harger copper bearing grease. It's tight. 
But I see your point.

 

I've seen them with an X cut in the strap, pushed down over the ground rod and 
silver soldered. It was pretty, but I didn't want to spend the time on my knees 
with a torch, and there's #2 cadwelded to the top of this rod running to the 
service entrance bond.

 

Good luck.

 

Mickey Baker, N4MB
Palm Beach Gardens
“Tell me, and I will listen. Show me, and I will understand. Involve me, and I 
will learn.” Teton Lakota, American Indian Saying.

 

 

On Sun, Oct 7, 2018 at 11:05 PM Jim <jimw7ry@gmail.com 
<mailto:jimw7ry@gmail.com> > wrote:

Did you see my response on the Tower Talk list?

 

I said…

 

 

Not the best way. But fine...

 

They corrode

They loosen up, I was never able to get mine to tighten up without spinning on 
the rod.

They are not NFPA 70 approved (National Electric Code) They are not UL approved.

 

If you have information to the contrary, please supply.

 

Thanks

73

Jim W7RY

Motorola Solutions R56 SME

 

 

 

 

From: Mickey Baker [mailto:fishflorida@gmail.com <mailto:fishflorida@gmail.com> 
] 
Sent: Sunday, October 7, 2018 9:56 PM
To: jimw7ry@gmail.com <mailto:jimw7ry@gmail.com> 
Subject: Re: [TowerTalk] Grounding wire choices

 

 


Jim

        9:56 PM (57 minutes ago)



John... How do you attach that 2" copper strap to ground rods? 73 Jim W7RY 

 

http://www.kf7p.com/KF7P/Ground_Rod_Clamps.html

 

73,

 

Mickey N4MB

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Tower Grounding and Lightning Protection, Jim <=