Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn RSL tower - slightly off topic

To: "k7lxc@aol.com" <k7lxc@aol.com>, "towertalk@contesting.com" <towertalk@contesting.com>, "bjtatum1@att.net" <bjtatum1@att.net>
Subject: Re: [TowerTalk] Rohn RSL tower - slightly off topic
From: Chuck Dietz <w5prchuck@gmail.com>
Date: Thu, 6 Jun 2019 12:32:13 -0500
List-post: <mailto:towertalk@contesting.com>
Maybe I’m dense, but I don’t see how this does anything (much). If the back of 
both antennas has a larger wind area than the front, the torque on the mast is 
going to twist the mast in the same direction no matter to which side it is 
attached.

Chuck W5PR

Sent from Mail for Windows 10

From: k7lxc--- via TowerTalk
Sent: Thursday, June 6, 2019 11:38 AM
To: towertalk@contesting.com; bjtatum1@att.net
Subject: Re: [TowerTalk] Rohn RSL tower - slightly off topic


>  Hello-? ? I was at a friend's QTH recently viewing his new Rohn RSL100L10, a 
>100' self supporter put together with 10' sections R-10H through R-1. It is 
>rated for 25 ft/2 wind load at 90 MPH, dropping back to 11 ft2 at 100 MPH. We 
>were discussing his planned installation of a KT-36 and M2 3 ele 40 meter 
>yagi. He wishes to have the KT-36 about 15' above the tower top plate with the 
>40 meter yagi approx. 1' or 2' above tower top. Both antennas are fairly close 
>in weight (approx. 95#), boom length (36') and wind load (10 ft2). ? I wanted 
>to get opinions of folks experienced with large antennas and self supporting 
>towers if this planned installation is OK for this tower.
Hiya, Byron --
    The proposed configuration sounds good to me but I'm not offering an answer 
to your question. What I am offering is a tower technique that I highly 
recommend.

    Install the antennas on opposite sides of the mast. That way many of the 
wind vectors cancel each other out. This was determined by Dick Weber, K5IU, a 
PE and the article appeared in QEX years ago. Anything you can do to reduce the 
wind induced torque on a mast is a good thing. Did I mention this is highly 
recommended?
Cheers.Steve    K7LXCTOWER TECH   

   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>