Correction to my numbers below, the number of guy thimbles is 18, not 174,
there are no thimbles required around the insulators ;) So the cost to
duplicate this with all new hardware is around $3600, not $4250. I'm open
to offers.
--- Rich K1CC
From: Rich Assarabowski [mailto:konecc@snet.net]
Sent: Monday, July 29, 2019 1:56 PM
To: towertalk@contesting.com
Subject: FS: Guy wire set for 120 ft tower
I have a set of guy wires for a 120 ft tower, 5/16 EHS, broken up every
12-14 feet with insulators. The lengths of the 3-level guy wire set are
approximately 100 ft, 120 ft and 150 ft. To duplicate this guy wire set at
DX Engineering would cost about $4250 (three 500 ft spools of 5/16 EHS, 78
502 strain insulators, 174 BG2146 preforms for 5/16 EHS and 174 3/8 THH guy
thimbles. I can provide exact lengths of each guy wire upon request. These
guy wires were removed from the main tower at NN1N two years ago and have
been stored indoors. I will accept a reasonable offer for the complete set.
Delivery along the east coast is possible or pick up in CT.
--- Rich K1CC
konecc@snet.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|