Bob,
Are you putting the rotator in the tower with a thrust bearing or sleeve?
73,
Scott K9MA
On 12/28/2019 10:39, Dave Hachadorian wrote:
I bought a 10-footer once from Texas Towers. They cut 1 foot off to
make it UPS shippable. That was a long time ago though.
Dave Hachadorian, K6LL
Yuma, AZ
-----Original Message----- From: Rob Matherly
Sent: Saturday, December 28, 2019 9:26 AM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Masting source
Hi All -
Could someone point me to a source for antenna mast? It needs to be
strong
enough for my A4S and 10-element 2m beam. I was thinking 10' in
height, is
that too much? I've not had an actual bell rotor atop a tower before.
Everything prior has been TV rotors on masts.
Thanks!
Rob Matherly, W0JRM
Centerville, Iowa - EN30nr
SKCC 29, FISTS 19246
"Aude, vide, tace, si vis vivere in pace."
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Scott K9MA
k9ma@sdellington.us
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|